How to fix a dishwasher: repair guide

dishwasher
The dishwasher is in almost every house — this small unit makes it much easier to work in the kitchen, saving our time and energy on washing and drying dishes. But, like any home appliances, even the best quality dishwasher begins to fail over time. Fortunately, most of the malfunctions that can occur during its operation can be eliminated independently, without dishwasher service Orange County.

 

 

In most cases, they are associated with the wear and tear of the main parts, as well as the consequences of an incorrect operating mode.
Usually, the symptoms of a breakdown are as follows:

  • Water does not warm up.
  • Machine shock you.
  • Water does not pour.
  • Water does not drain.
  • Water overflows.

If you notice these breakdowns, you may not go to the dishwasher service Orange County. You could try to repair by yourself.

Water does not warm up
Heating in the dishwasher is done by a heating element installed at the bottom of the dishwasher chamber. Complex models are equipped with a thermal sensor that allows the machine to heat water to a certain temperature in accordance with the selected mode. In machines in the event of a sensor burnout, the operation stops altogether, since the water can not heat up to the desired temperature, the temperature sensor does not work, and the washing process can not be continued. Dishwasher repair the automation itself will not succeed. But the heating element can be replaced.
Machine shock you
With a probability of 99%, the heating element is also to blame. It struck. Dishwasher repair service Orange County recommend removing the thermal element, inspect it. Usually, cracks and defects are visible during visual inspection. You can put the element in salt water and measure the resistance between one of its electrodes and the salt solution. The presence of conductivity indicates breakdown. However, this method of measurement does not always give the correct result. In some rare cases, a punctured heating element does not show conductivity. The cause of burnout or breakdown of the heater is usually too hard water and neglecting the use of salt for the regeneration of the softener.
Water overheats
After a while, steam starts to fall out of the car after a set of water. Washing does not begin. A water temperature sensor or brains that control the heating element has failed. You can buy it at the dishwasher service Orange County and remove.
dishwasher-repair
Water does not pour
There can be several reasons. The dishwasher repair includes next steps — First, the water supply valve is faulty. This valve is installed immediately after the water supply connection from the water supply. It usually together with this branch pipe forms a monolithic non-separable structure. Secondly, the mesh, which is installed between the hose from the water pipe and the inlet branch pipe, was clogged. Third, the water level sensor is defective. The machine all the time it seems that the water has already poured.
Water does not drain
Faulty drainage unit (valve and pump). They should be replaced. Usually this is a single unit.
Water overflows
After a while the water starts to flow from all the slots from the machine. The level sensor is defective. But, unlike the previous version, it now shows a constant lack of water. This fault is unpleasant in terms of flooding the neighbors from the bottom, but is not dangerous for the heating element. This sensor is usually installed at the bottom of the machine. Turn the dishwashing machine over, remove the bottom cover and replace the sensor.




Добавить комментарий

Ваш e-mail не будет опубликован. Обязательные поля помечены *